DTC P0726
OBD-II code P0726 indicates a problem with the input speed sensor circuit, specifically that the PCM (Powertrain Control Module) has detected an abnor
I have this code
Add your car and symptoms to get a more practical first step.
βΉοΈ What does it mean?
OBD-II code P0726 indicates a problem with the input speed sensor circuit, specifically that the PCM (Powertrain Control Module) has detected an abnormal signal from the transmission input speed sensor. This code is set when the PCM receives a signal that is out of range or not consistent with expected values. Commonly seen in vehicles like the Ford F-150, Toyota Camry, and Honda Accord, this code can be triggered by issues with the sensor itself, wiring, or connectors. The ECU/PCM stores this code to alert the technician of a potential issue affecting transmission performance and vehicle drivability.
π Symptoms
- β’ Harsh or erratic shifting, where the transmission may shift roughly or unexpectedly.
- β’ Slipping transmission, which can cause a loss of power during acceleration.
- β’ Check Engine Light illuminated, indicating a fault detected by the PCM.
- β’ Poor acceleration, where the vehicle struggles to gain speed.
- β’ Increased fuel consumption due to improper shifting patterns.
β οΈ Possible Causes
- β Faulty input speed sensor, which may have failed internally or developed a poor connection.
- β Damaged wiring or connectors, particularly at the sensor or PCM, which can lead to signal loss.
- β Corrosion at the sensor connector, especially common in vehicles exposed to harsh environments.
- β Transmission fluid issues, such as low levels or contamination, affecting sensor performance.
- β Faulty PCM, though less common, can misinterpret signals from the input speed sensor.
π Can I drive with this code?
π οΈ How to Fix
- 1 Inspect the input speed sensor and connector for damage; replace the sensor if it shows signs of wear or failure, typically costing around $80.
- 2 Check the wiring harness for continuity using a multimeter; you should see resistance below 5 ohms between the sensor and PCM connectors.
- 3 Examine the transmission fluid level and condition; top off or replace fluid if it is low or contaminated.
- 4 Clean the sensor connector and apply dielectric grease to prevent future corrosion.
- 5 If issues persist, consider reprogramming or replacing the PCM after confirming all other components are functioning properly.
π° Estimated Repair Cost
π From Fixlith Scan users
Scan your car with Fixlith Scan
OBD-II Scanner Β· AI Diagnostics Β· DTC Decoder
- Scan P0726 instantly
- AI-powered cause analysis
- Repair cost estimate